![]() ![]() The image below demonstrates an inbound route that will send ANY call to a certain extension. To start select "Inbound Routes" from the "Connectivity" menu on your FreePBX interface. To direct calls from to an extension you must create an inbound route. After entering this info, and hitting "Submit" then "Apply Config." You can dial outbound through your SIP.US trunk. Calling), 11 Digits (North American Calling), and International Calls (starting with 011). They will allow for you to dial 3 digits (think 911), 10 Digits (U.S. Enter dial patterns exactly like the image below. Select "Connectivity" then "Outbound Routes." To create a new "Outbound Route," you must first enter a distinctive "Route Name." Then select the trunk you just created as the top route in "Trunk Sequence for Matched Routes." ***Note that we created a second trunk to and added in the Trunk Sequence section for redundancy.*** It is time to create an "Outbound Route" so we can dial out through. Select the "Codecs" sub-tab under the "pjsip Settings" tab. Additional Note: You will need to add the trunk number in the From User field which is directly under the From Domain. You must edit the "From Domain" field to say. Select the "Advanced" sub-tab under the "pjsip Settings" tab. "Authentication" should be set to "Outbound," and "Registration" should be set to "Send." Enter "" in the "SIP Server" field, and "5060" in the "SIP Server Port." The "Secret" is the password for your trunk found under the "show password" link in your portal (THIS IS NOT THE SAME AS YOUR LOGIN PASSWORD FOR SIP.US). Enter your Trunk Number (usually starts with 52) as the username. Select the "pjsip Settings" tab and edit the settings under the "General" sub-tab. The only field which is important at this time is the "Trunk Name." You must enter some sort of distinctive name for this trunk. ![]() When you create a trunk with PJSIP, you should be dropped off into a screen similar to the one below. These instructions will help you set up a trunk using PJSIP on FreePBX 13. However, some people wish to use PJSIP for one reason or another. The module uses the traditional library by default. You can create a trunk using either library. In FreePBX version 13, these libraries are used by default on port 5060, while the traditional CHAN_SIP_C libraries were relegated to port 5061. Starting with FreePBX version 12, the PJSIP libraries were introduced. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |